If you have an old school turntable you are trying to connect to newer technology you most likely will need this AND the ground wire, the ground wire helps to disperse the bad waves to a non audible source and keeps the good sound going where it should, to simplify the why, if you do not ground your turntable you could still have a hum. If you have a turntable that has a built in preamp you should not need this, read up on your system as some newer ones have one built in and it's a matter of flipping a switch on the turntable. Now it will play on my sonos without me using my HTD controller but it won't hit my wired speakers in group until I turn that on but when I do it all works. Tilting head questioning again, more googling.įor my system, my controller controls the volume up and down not the music source, I had to put the sonos sound level for the line in to 10, auto delay to medium, autoplay on to include grouped rooms but turned off autoplay volume, this makes it so music will start once the needle hits the vinyl, line out level is pass through because I have a controller, and wala, sound. Placed preamp next to turntable on shelf above controller and amplifier, only about 6 to 8 inches apart but shelf appears to add a buffer. My final setup is removing my receiver altogether, turntable to "in" on preamp, preamp "out" to sonos connect "in", sonos is connected to controller, ground wire connected to turntable and preamp. the most important thing to know, if you connect this preamp and put it too close to an amplifier or other high electric output it will still hum, this needs to be seperated a little bit, keep reading. NOTE TO THOSE CONNECTING TO RECEIVER OR OTHER THAN AN IN WALL HOME SYSTEM. I started all over again preforming the same connections as before but with the turntable ground wire connected, initial loud hum happened, then went away and had dead silence. I ordered a factory ground wire for my turntable and this preamp with the ground connection, then. Researched, completely baffled, did I lose my techi touch? Scratching head, discouraged, defeated? Not on your life! I then tried to connect the preamp "out" to my sonos connect "line in" bypassing the receiver, same results, then tried connecting directly to my controller, same results. I initially connected the turntable to the preamp "in" that I had, not this new one, with no ground, then connected the preamp "out" to my receiver "in", then receiver "out" to my controller "in", no sound and loud annoying hum. The turntable I purchased used is a mid to high grade Technic, came with a Pyle preamp that had no ground, turntable did not come with ground wire either, this is important, noted later. I hooked up this system myself, I am very tech savvy, takes alot to stump me. system, using sonos as well as wired speakers with the HTD control module and amp. Read in entirety: I purchased a Technic turntable, old-school, have a complete zone home ent.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |